Diy sliding door trim 1 remove the baseboard where the door trim will be i measured out the width of the 1 6 and the 1 2 and used my handy.
Trimming out a sliding glass door.
3 attach the 1 6 door trim to the.
Step 8 repeat steps 6 and 7 for the other edges fitting the wood trim to each other at the beveled edges.
Create a sill pan to fit in the opening using roll flashing.
Things you ll need utility knife pry bar screwdriver hammer tape measure sliding glass door level shims or plywood strips optional nails flashing tape insulation optional.
Use the phillips screwdriver to turn these screws counter clockwise.
Put silicone caulk around the edges of your opening where your siding and house wrap meet.
2 cut and attach hardboard to inside of door frame this step is not applicaple if you already have smooth walls.
Secure the first piece with your carpentry nails.
If this is the case it is recommended to put the molding up around your sliding glass door piece by piece.
You ll also want to put a few.
Once it is out of the frame tilt the door slightly so that it comes out entirely.
Now lift the door up and out of the track use the screwdriver for this.
Press the wood trim flat to the edge of the sliding door opening and hold it there for several seconds allowing the epoxy to grip.
Add caulk to the bottom edge of the opening and firmly.