Treating Cut Pressure Treated Wood

After pressure treated wood gets soaked wood can crack twist bend and cup until it tears apart.

Treating cut pressure treated wood.

The chemical used in pressure treating wood is not safe for humans and to pets. Outlast q8 log oil is the best choice for this purpose because it contains 675 copper 8 quinolinolate to meet the awpa m 4 standard for end cuts bore holes and fastener punctures and it is virtually odorless while drying invisibly into the end grain. This chemical is composed of arsenic especially in all older pressure treated lumber and some new materials. Pressure treated wood is wood that has a preservative forced deeply into it.

Wooden steps and patios located outdoors can quickly absorb rainwater and snow causing the wood to warp erode and eventually rot. Copper is also used in the newest pressure treatment formulas and does not pose threat to health unlike arsenic. Cut n seal is not to be used in ground contact applications in preserved wood foundations to recoat pressure treated wood surfaces or as a replacement for pressure treatment. This causes it to be resistant to decay and insects.

Shake or stir contents before and during use. How to seal your wooden deck pressure treated lumber is notoriously difficult to stain and seal compared with other decking materials which is why some manufacturers actually used to advise against it. Ready to use do not dilute. Pressure treated lumber is wood like pine or fir that has been injected with a preservative in order to make it last longer on outdoor projects like fencing or decks.

Treat wood to repel water and insects. So while the pressure treatment process does provide a certain degree of protection sealing your pressure treated wood will help it to look better and last longer. When cutting thick pieces of wood such as fence posts the preservative may not have soaked all the way to the center of the lumber. Wood should be dry and clean.

Once the ends have been cut however additional care must be taken in order to maintain the same level of resistance. Do not use for pressure treated wood in ground contact applications or in preserved wood foundations. Cut n seal is not recommended to replace pressure treatment. Use cut n seal on areas that have been drilled or saw cut in treated wood deck boards railing post tops fence boards etc.

Treating wood with a water seal helps it repel moisture blocks harmful insects and keeps the wood looking its best. What you must remember is that pressure treating makes the wood resistant from rot and pests however it will not make wood resistant to water. Do not use to recoat pressure treated wood surfaces. Pressure treated wood can still be affected by water when it is soaked or splashed.