The drywall cut is fairly good so i m considering just putting a bull nose pieces down the line and later filling the gap with drywall mud as i go over it after the tile is in place.
Transition from tile to drywall corner.
The easiest way to transition from tile to drywall will be using what s called a schluter profile it is a material often used by professional builders and usually adds a metal accent to your finish.
Step 1 create a straight end to the drywall by either making a straight cut with a drywall saw or installing an extra strip of drywall to close the space between the drywall and where the backer board will end.
Skim with mud to smooth it and seal with paint.
The walls of the bath alcove are tiled 7 feet up.
Then red guard it.
7 16 cement board vs 1 2 drywall transition woes tiling unslightly transition from tile to drywall need advice hardibacker to drywall transition ceramic tile advice forums how do i finish this tile to drywall transition corner how to seamlessly transition crown molding where tile meets the how to seamlessly transition crown molding where tile meets the.
As it turns the corner and leaves the alcove the wall is tiled up to 4 ft approximately.
On one side i have hardiebacker that sits about 1 8 deeper than the surface of the drywall at the transition.
I ve left the drywall unfinished on that edge assuming the tile guy would tile to the corner and finish with caulk.
Tile drywall corner transition.
Step 2 install additional two by four backing in the wall where the joint between backer board and drywall will be.
This detail provides a flush transition from the wall tile to the drywall and a capillary break from the shower to the drywall.
I would use a nail on cornerbead thinset one side mud the other.
I m trying to figure out how to complete the corner where the finish transitions from tile to drywall.
Because the tile work needs to meet the drywall bead perfectly the drywall bead needs to be installed perfectly.
I have a bath situated in an alcove.