Torsion Bar Garage Door Installation Instructions

Follow the track bolt placement figure.

Torsion bar garage door installation instructions.

After the springs are installed proceed to page 6 step 35 of the door installation instructions to finish the installation. Insert the bolts in the stationary cones of the new torsion spring and insert the bolts in the slots on the spring anchor bracket. Tension is reduced by removing turns. For torsion spring installation go to page 7 of the door installaton instruc tions.

With locking pliers clamped on the torsion tube winding bars are used to wind the springs tighter to increase tension. It covers installation of torsion springs step 14 of the manual. Adjustments should be made in 1 4 turn increments. Flying off can damage cars other property or even a person who is in the garage when it happens.

To adjust torsion spring tension the door is locked in the down position. For extension spring installation go to page 7 of these instructions. Securely mounted hardware and rails. For instructions on how to install a new garage door opener see how to install a garage door opener.

Make sure that the bearing is inside the stationary cone. Read the information in both. Torsion springs 1 6 19 w a r r a n t y 3 1 read this manual carefully and observe all warnings when installing operating or maintaining your garage door. Supplemental instructions torsion spring installation this is a supplement to the residential garage door instructions referred to as the manual.

Installation of rear torsion spring system. Residential sectional garage door installation instructions series 321 323 327 329. When two springs are used both sides should be adjusted the same. Steel residential garage door installation instructions and maintenance 1 and 2 layer construction in this manual you will find safety information how to prepare the opening installing the new door painting maintenance and replacement parts.

For all other information and safety warnings concerning your garage door see the manual. Finger tighten nuts on bolts until the stationary cone is flush against the center bearing plate. Torsion spring brackets should be firmly mounted to the wooden header above the door. 8 align the lhr rear upper track to the standard track so that the gap between the lhr front and lhr rear upper tracks is not greater than 1 8.

Mark the position on the standard track through the lower hole in the front splice plate connected to the lhr rear upper track.