Tools supplies rubber mallet chisel wood glue large metal bar clamps shop rags panel or skill saw compound miter saw optional orbital or belt sander sand paper 80 120 220 wood filler and metal spatula i made mine at techshop san franc.
Tongue and groove flooring table top.
My wife and i met there.
Table top from old tongue and groove maple flooring.
Make sure the frame is the correct height so that the flooring boards will be flush to the top edge of the frame.
So there is a bit of sentimental value in this flooring.
The new top is old tongue and groove pine attic flooring from the early 20 s.
My hubby carpenter cut the pieces of flooring to length.
Here are the steps we took to build the hardwood floor table top.
Attach the boards to the sides of the tabletop using 2 finish nails.
Tongue and groove flooring 101 find out why these smooth level surfaces have triumphed over their predecessors and get top tips for diy installation.
To rip off the tongue and groove edges set the table saw to the width of the tongue groove and run the board through the saw.
How to make a reclaimed tongue groove table top.
He cut off all the outside edges removing either tongue or groove to give it a more finished look.
This type of table top assembles the same way except that the table top will have grooves.
Feb 1 2014 a table i made from leftover tongue and groove flooring.
Steve and hannah are making tongue and groove flooring for a bathroom remodel.
I made a frame of the same wood and it anchors the piece.
The birch was felled on the property and milled on a woodmizer lt15 sawm.
The maple flooring is from a local skating rink that was torn down after a flood.
Long story short on the source of the flooring.
To begin cut all of the boards you want to use for your tongue and groove assembly to a length of at least one inch longer than the desired finished length using a circular saw or compound.