Toilet On Uneven Floor

Measure the depth and width of the gluing edge of the bowl.

Toilet on uneven floor.

Then make an outline of the toilet on the floor with masking tape. If the flange is a little higher than the surrounding flooring the toilet becomes raised slightly in the center allowing it to rock to either side. Just because a surface is uneven doesn t mean that you can t set a toilet there. Underneath the toilet base is a round toilet flange that connects the toilet to the drain pipe.

In this video this old house plumbing and heating expert richard trethewey explains how to fix a wobbly toilet. Remove the toilet and turn it on its side. Next move your caulk gun to the inset depth you just measured and apply caulk directly to the floor maintaining the inset depth as you follow the tape. Set a toilet on an uneven surface with help from a foreman for lighty contractors in this free video clip.

However even a small tilt of the toilet on an uneven floor can. Toilets usually rock because they are not resting flush against the floor. Toilets are sealed to the floor flange with a wax ring but the height of the flange and the tightness of the flange bolts that secure the toilet to the floor can affect the ring s ability to create a watertight seal. You also want to make sure the toilet sits level and does not rock on the floor as this can compromise the seal.

1 turn off water to toilet by closing shut off valve. Lay a level lengthwise on the back of the toilet tank then sit backward on the toilet straddling the bowl and. Tip the toilet on its side and install a new wax ring seal in the drain hole then carefully set the toilet onto. Few toilets are installed on a floor so unlevel that you have a good chance of falling off the side before you finish your business.

When you are replacing a toilet or resetting an existing toilet after a repair there are a few key things to check to ensure a good seal and prevent leaks. 2 flush toilet and hold down the lever to empty tank. Turn the valve on the 3 8 or 1 2 inch line supplying water to the toilet tank clockwise until it is tight in the off position. Lift the lid from the top of the toilet tank and set it aside.